Hurco winmax - Page 300

XXII - Index v546CO WinMax Lathe Conversational Part Programming
194
V
VERTICAL LEAD IN field
Threading cycle 2-42, 2-44, 2-46,
2-48, 2-49
VERTICAL LEAD OUT field
Threading cycle 2-42, 2-44, 2-46,
2-48, 2-50
W
W coordinate 2-5
W Offset (Tailstock or Sub-spindle) check-
box
Change Part Setup 2 - 196
W OFFSET (Tailstock or Sub-spindle) field
Change Part Setup 2 - 196
W POSITION, Cutoff Block screen 2-63
WALL ALLOWANCE field
Axial Mill Circle screen 2-149
Axial Mill Contour screen 2-130
Axial Mill Flats screen 2 - 169
Axial Mill Frame screen 2 - 155
Axial Mill Slot screen 2 - 161
Radial Mill Circle screen 2-91
Radial Mill Contour screen 2-73
Radial Mill Frame screen 2-97
Radial Mill Slot screen 2-103
WHERE field, Position data block 2-4, 2-
8
WIDTH COMPENSATION field
Cutoff block 2-64
WIDTH field
Axial Lettering screen 2-177
Radial Lettering screen 2 - 112
WRITE TABLE TO FILE F2 softkey
Part Setup Work Offsets 2 - 197
X
X (RAD) or (DIA) field
Cutoff Block Advanced Pecking tab 2-
65
User Defined Tool Change Position field,
Program Parameters screen 2-
194
X Axis Order 2-6
X BOTTOM (DIA) or (RAD) field
Grooving 2-55
Radial Mill Circle screen
Rotary Coordinates 2-93
Radial Mill Contour screen
Rotary Coordinates 2-76
Radial Mill Frame screen
Rotary Coordinates 2 - 101
Radial Slot screen
Rotary Coordinates 2 - 107
X BOTTOM field
Radial Holes Drill Operation screen 2-
115
X CENTER (D) or (R) field
Arc Element screen 2-32
Blend Arc Element screen 2-35
X CENTER field
Axial Bolt Circle screen
Rectangular Coordinates 2-186
Axial Mill Circle screen
Rectangular Coordinates 2-152
Axial Mill Contour Arc Segment screen
Rectangular Coordinates 2-141
Axial Mill Contour Blend Arc segment
Rectangular Coordinates 2-145
X CLEARANCE field
Threading 2-41, 2-43, 2-45, 2-47,
2-49
X coordinate 2-5, 2-8
X CORNER field
Axial Mill Frame screen
Rectangular Coordinates 2-159
X END (D) or (R) field
Arc Element screen 2-32
Blend Arc Element screen 2-35
Chamfer Element screen 2-37
Cutoff block 2-63
Face Element screen 2-29
Taper Element screen 2-31
Threading Cycle 2-49
Turn Element screen 2-28
X END field
Axial Mill Contour Arc Segment screen
Rectangular Coordinates 2-141
Axial Mill Contour Blend Arc segment
Rectangular Coordinates 2-144
Axial Mill Contour Line Segment screen
Rectangular Coordinates 2-137
Axial Mill Slot screen
Rectangular Coordinates 2-165
X field
Axial Locations screen
Rectangular Coordinates 2-184
X LENGTH field
Axial Mill Frame screen
Rectangular Coordinates 2-159
X OFFSET
checkbox 2 - 195
manufacturer’s allowable offset 2-58
X OFFSET field 2-59
Change Part Setup 2 - 195