Front brake lever adjustment and uid level check (SMR)
The lever (1) can be adjusted (4 settings available) to suit the rider's hand size.
To decrease the lever (1) distance from the handgrip, turn the adjuster screw
(2) COUNTER CLOCKWISE “A”.
Fluid level inside master cylinder tank shall never be below the min. level (3)
indicated on the transparent tank (4).
A decrease of the uid level will let air into the system, hence an extension of
the lever stroke.
If the brake lever feels mushy when pulled, there may be air in the brake
line or the brake may be defective: CHECK THE BRAKING SYSTEM
(see Section "L").
Too much brake lever free play may reduce braking action: CHECK
BRAKE PAD THICKNESS (see Section "L").
Do not spill brake uid onto any painted surface or lens (for example lights
lens).
Do not mix two brands of uid. Completely change the brake uid in the
brake system if you wish to switch to another uid brand.
Brake uid may cause irritation. Avoid contact with skin or eyes. In case
of contact, ush thoroughly with water and call a doctor if your eyes were
exposed.
To Next Page
Loading...
