Husqvarna TE511 - Rear Mudguard Removal

E.6
H02407
1
H02408
2
H02409
4
3
1
st
edition (08-2010) _Rev. 11-2010
GENERAL PROCEDURES
Rear Mudguard Removal
- Remove the saddle, the two side panels and the number plate holder (TE -
SMR) as described in the relevant paragraphs.
- Using a 8 mm wrench, loosen the two screws (1) positioned under rear
mudguard, disconnect connector (2) (TE - SMR), and remove tail light.
- Using a 8 mm wrench, loosen the two front retaining screws (3), and remove
the complete mudguard (4).