EasyManua.ls Logo

Husqvarna TE511 - Air Filter Check; Air Filter Cleaning

Husqvarna TE511
385 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
D.16
H006149
2
H006150
4
3
H006148
1
H006151
5
1
st
edition (08-2010) _Rev. 11-2010
SETTINGS AND ADJUSTMENTS
Air lter check
- Remove the saddle and right-hand side panel, as described in the relevant
paragraphs.
- release retaining clips (1), and slide lter (2) out of vehicle right side, taking
special care not to damage the two retaining hooks;
- widen the two retaining tabs (3) and remove subframe (4) with sponge (5);
- remove sponge (5) from subframe (4) and check if it needs cleaning or replacing;
- ret all the disassembled parts in reverse order, making sure to position lter
sponge (5) with the "TOP" wording facing up. Ret lter (2) inside guides,
push it all the way down and lock it using the clip-on fasteners (1).
Air lter cleaning
Wash the filter with a specific detergent (CASTROL FOAM AIR FILTER CLEAN-
ER or similar) then dry it fully (wash filter with gasoline only in case of need).
Plunge the filter in special oil for filters (CASTROL FOAM AIR FILTER OIL or
similar), then wring it to drain superfluous oil.
Do not use fuel or a low flash-point solvent to clean the filtering element.
A fire or explosion could result.
Clean the filtering element in a well ventilated area and do not allow
sparks or flames anywhere near the working area.

Table of Contents

Related product manuals