1.4 Preventive Maintenance Function
C1-9
ME0384-4A
Chapter 1 Maintenance and Inspection
[Maintenance Information Setting in Teaching Tool]
Maintenance information can be checked and set with the following procedures.
• TB-02/TB-03 [Monitor] → [Maintenance]
• TB-02/TB-03 [Information] → [Maintenance Information]
• PC software [Monitor (M)] → [Maintenance Information (I)] → Axis selection
As a reference, shown below is how to operate using a teaching pendant TB-02.
Refer to an instruction manual for each teaching tool for detail.
● Switchover to Maintenance Information Screen Using TB-02
Touch "Information" on the Menu 1 screen.
The screen will switch to the Information screen.
If the TP operation mode is not Monitor mode,
a confirmation screen will appear for
switching to Monitor mode.
Touch "Maintenance information" on the
Information screen.
The maintenance information screen opens.
To Next Page
Loading...
