1.4 Preventive Maintenance Function
C1-10
ME0384-4A
Chapter 1 Maintenance and Inspection
● Basic Operation in Maintenance Information Screen Using TB-02
To set the target value,
touch the Edit button of the relevant item.
The set value will blink and Ten Key
screen will open.
Enter the value with the Ten Key pad
and touch the [ENT] key.
• The target value will change.
If you touch [ESC],
the target value will not be changed and
the original screen will return.
• A confirmation message will be displayed
to reboot the controller when leaving the
maintenance screen.
The setting change will take effect
after rebooting.
If the actuator has been replaced,
touch the "Actuator replacement" button.
"Total travel count" and "Total travel distance"
will be cleared to "0".
To Next Page
Loading...
