IAI Rcon - Page 600

1.4 Preventive Maintenance Function
C1-11
ME0384-4A
Maintenance Section
Chapter 1 Maintenance and Inspection
PSA-24 Status Data Monitor
IAI 24V DC Power Supply Unit: PSA-24 possesses a feature to monitor the status data from a
host device as a preventive maintenance feature in purpose of improving efficiency of
management and maintenance for equipment.
For the preventive maintenance features equipped on PSA-24 other than status data monitor,
refer to “PSA-24 Instruction Manual (ME0379)”.
[How to Establish Connection]
Connect the gateway board on RCON to PSA-24 in order to monitor the status data of the power
source via RCON. If it is preferred to monitor the status data using the PC software (Software
Version RCM-101: V13.00.00 and later), establish the connection using the USB interface on
RCON.
As the status data of the power source is also uploaded to the field network, it is available to
monitor the status data in the host network via PLC. (For details, refer to "Chapter 3, 3.7 Address
Configuration/ Power supply unit (PSA-24) status signal".)
Monitoring in PC software via USB
Power Supply Enclosed Connector
RCON Enclosed Connector
5 units max.
Remote Monitoring via PLC