2.1 List of Actuator Specifications
D2-46
ME0384-4A
Chapter 2 Connectable Actuators
Specifications for 200V AC Servo Motor Type Actuator
Shown below is a list of the actuator specifications connectable to the 200V driver unit.
Refer to the instruction manual of SCON-CB Controller for the actuator specifications
connectable to SCON-CB Controller (RCON connection type).
Note The following 200V servo-motor actuators cannot be connected to the 200V driver units.
(1) Motor types other than those from 60W to 750W
(2) Encoder types other than battery-less absolute, incremental, spurious absolute or index
absolute type
(3) For 3-Phase 200V ········· Combination that exceeds 2400W for total wattage of
actuators connected to 200V driver unit
(4) For Single-Phase 200V ·· Combination that exceeds 1600W for total wattage of
actuators connected to 200V driver unit
(5) Servo press type
(6) SCARA robot
(7) CT4 series
(8) ZR series
When connecting the actuators described in (1) to (4), use SCON extension unit and SCON-CB
(RCON connection specifications).
Also, DD/DDA and LSA-W21S are not applicable for the single-phase 200V.
To Next Page
Loading...
