Table 52. Main Error Codes (continued)
Error Code Description User Action
C0 Network initialization failed
1. Refer to “Isolating Web User
Interface problems” on page 198.
2. If the error recurs, refer to
“Contacting IBM technical
support” on page 219.
C1 Telnet Interface initialization failed
C2 Webserver initialization failed
C6 Ping command did not reach target
C7 Cannot Upgrade from USB Not supported
C8 Cannot Upgrade from FTP
1. Retry the Firmware upgrade.
2. If the error recurs, refer to
“Contacting IBM technical
support” on page 219.
C9 Cannot Upgrade Robotic from Flash
D0 ROM error. ROM checksum incorrect Refer to “Isolating a library controller
card versus accessor enclosure
problem” on page 197. Possible
replacement CRUs:
v Primary: Library Controller Card
v Secondary: Library Enclosure
*D7 - Fatal System error can occur
because of an over-temperature
condition. Ensure that the
environment meets the
Environmental Specifications (refer to
“Environmental specifications” on
page 15).
**If you receive a D8 error while your
library configuration is restored from
the OCP or Web UI, verify that your
file extension is .dbb. If the extension
is correct, your file was corrupted
during the save. Reconfigure, then
save your library configuration.
Note: Configuration files that are
saved with one version of library
firmware might not be compatible
with other versions of firmware. It is
recommended to save a configuration
file each time the library firmware is
upgraded. Restore the library using a
configuration file that was saved
with the same version of firmware
that is currently installed in the
library.
D1 RAM error. Power on Self Test (POST) failed
D2 NVRAM (Non-Volatile Random Access Memory) error.
Read/Write operation to NVRAM failed
D3 CTC (Channel to Channel) Error. Timer unit failed during
POST.
D4 UART (Universal Asynchronous Receiver Transmitter) Error.
Frame overrun or Parity Error on serial Interface.
D5 Display Error
Communication to display failed
D6 Memory Error, Stack and heap overflow.
D7 Fatal system error*
D8 Database error**
D9 No SCSI IC detected
DA While the Library Verify Test is running, the bar code reader
reads different bar code data for the same customer-supplied
scratch cartridge label.
1. Check the barcode label on the
scratch cartridge and run the
Library Verify test again.
2. If the error recurs, refer to
“Contacting IBM technical
support” on page 219.
DB Warning Event! See Table 54 on page 211
204 IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573
To Next Page
Loading...
Need help?
General
