9-82 FLIGHT CONTROLS / YAW CONTROLS
ICON A5 / MAINTENANCE MANUAL CHANGE C3
FIGURE 9-52
RUDDER CABLE TENSION CHECK LOCATION. VIEW IS LOOKING DOWN FROM WITHIN THE
ACCESS HOLE.
6. Remove all installed rig pins:
a. Water Rudder Bellcrank Rig Pin.
b. FWD Yaw Bellcrank Rig Pin.
7. Install Center Console Bucket using retained hardware during removal. (See “Center Console
Bucket Installation” on page 8-8.)
8. Install the Water Rudder Access Panel using retained hardware during removal. (See “Removal
and Installation of Inspection Panels and Fairings” on page 3-34.)
9. Install AFT Bulkhead Baggage Panel using retained hardware during removal. (See “Baggage
Sidewall Panel Installation” on page 3-45.)
VERIFICATION METHOD:
Record results and check against requirement. If requirement is not met complete rudder rigging. (See
“Inspect Yaw Rigging” on page 9-85.)
To Next Page
Loading...
