ICON A5 - Page 417

HORIZONTAL TAIL / HORIZONTAL TAIL TIP PIN 12-19
CHANGE C1 ICON A5 / MAINTENANCE MANUAL
CHAPTER 12
12.4 Horizontal Tail Tip Pin
12.4.1 Inspection Instructions
12.4.1.1 Measure Horizontal Tail Tip Anti Rotation Pin Wear
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
None
Special Tools Required
None
Parts Required
None
Aircraft System and Number
09—Horizontal Tail
Consumables
None
TASK INSTRUCTIONS:
1. Pull downward on the tip lock latch to remove it from the detent position and rotate the latch
approximately 180°.
2. Grasp the tip and slide it away from main horizontal tail until the cylindrical spar clears the struc-
ture.
3. Support the horizontal tail tip on a soft protective surface.
4. Inspect the minimum pin diameter of the two anti-rotation pins that protrude from the surface of
the tip’s root rib. Inspection can be completed with a micrometer, caliper, or gage pin.
NOTE: Pin diameter measurement needs to be taken on the circular
surface of the pin, avoiding the flats used for removal.
VERIFICATION METHOD:
Record results and check that wear is within these limits. Replace if outside limit (See “Horizontal Tail
Tip Pin” on page 12-20.)