13-18 INSTRUMENTS (AND AVIONICS) / INSTRUMENTS AND AVIONICS GENERAL MAINTENANCE
ICON A5 / MAINTENANCE MANUAL CHANGE C2
9. Install the overhead console bezel by engaging the tabs at its aft edge, then swinging the forward
edge up until the spring fasteners snap into place.
10. Push the four light control knobs onto their D-shafts.
VERIFICATION METHOD:
Check the correct function of a replaced component.
RELATED INFORMATION:
"ELT Audio Alert Indicator Battery Replacement" on page 13-52
"ELT Remote Control Panel Battery Replacement" on page 13-50
"Remove Dome Light Switch" on page 6-64
"Install Dome Light Switch" on page 6-65
13.3.2 Replace Overhead Console Fuses
Use this procedure to replace any indicated fuse mounted in the overhead console shown in Figure
13-1.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
10—Instruments (and Avionics)
Consumables
None
To Next Page
Loading...
