ICON A5 - Page 483

INSTRUMENTS (AND AVIONICS) / VHF COMM ANTENNA 13-63
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
CHAPTER 13
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
10—Instruments (and Avionics)
Consumables
None
The comm antenna is located on top of the horizontal tail.
TASK INSTRUCTIONS:
1. Remove antenna 4 8-32x1.00 screws.
2. Raise the antenna from the horizontal tail surface to disconnect the BNC connector.
VERIFICATION METHOD:
This task is complete when the comm antenna has been removed from the aircraft.
13.6.3.2 Comm Antenna Installation
These instructions are to be used to install the comm antenna after transportation or repair.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None