ICON A5 - Page 520

14-12 LANDING GEAR / TROUBLESHOOTING
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 14
RELATED INFORMATION:
"Condition and 100-Hour Inspection—Landing Gear" on page 3-14
"Empty Weight and CG Measurement While on Jackpoint Scales" on page 3-32
"Retraction and Extension Time" on page 14-12
14.3.5 Retraction and Extension Time
The following should be used to inspect the landing gear retraction and extension time.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
Wing Jack Point Adapter—ICA009750
Parts Required
None
Aircraft System and Number
11—Landing Gear
Consumables
None
This task can be readily combined with the Landing Gear Indicator Lights task. (See “Landing Gear Indi-
cator Lights” on page 14-10.)
TASK INSTRUCTIONS:
1. Verify Key Switch is in OFF position.
2. Follow jacking procedure to lift the aircraft off the ground.
3. Move Master Switch to ON position.
4. Move Landing Gear Lever to UP position.
5. Using stop watch, immediately start timer for retraction.
6. Stop timer when center consoled UP indicator lights.
7. Record elapsed time.
8. Move Landing Gear Lever to DOWN position.
9. Immediately start timer.