14-68 LANDING GEAR / NOSE LANDING GEAR
ICON A5 / MAINTENANCE MANUAL CHANGE C2
9. Perform the verification steps below and correct any deficiencies.
10. Install the nose landing gear forward door assembly. (See “Removal and Installation of Inspection
Panels and Fairings” on page 3-34.)
VERIFICATION METHOD:
1) Lift the nose of the aircraft so that the nose tire is clear of the ground. Rotate the nose wheel
360° left and right and confirm smooth motion.
2) Rotate the nose wheel left and right and confirm that the wheel self-centers to the in-trail posi-
tion. Lower the nose back onto the ground.
RELATED INFORMATION:
"Nose Landing Gear (NLG) Leg Assembly Installation" on page 14-62
14.7.2.6 Nose Landing Gear Steering Bearing Replacement Procedure
Use the following procedures to replace the nose landing gear steering bearing.
14.7.2.6.1 Remove Nose Landing Gear Steering Bearing
This task is used to remove the nose landing gear steering bearing before it is replaced.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
Nose Gear Bearing Installation/Removal Tool
Parts Required
None
Aircraft System and Number
11—Landing Gear
Consumables
None
To Next Page
Loading...
