14-72 LANDING GEAR / NOSE LANDING GEAR
ICON A5 / MAINTENANCE MANUAL CHANGE C2
gear leg and begin to press the nose landing gear into position. Bearing should end up flush on
top and bottom of the nose landing gear leg.
7. Remove ICON nose landing gear bearing install/removal tool. Clean up adhesive that squeezed
out during the installation. Excess uncured adhesive may be removed with a cloth and isopropyl
alcohol. Clean up any adhesive that may have gotten on the inside of the bearing.
8. Remove masking tape.
9. Allow the adhesive to cure. LOCTITE
®
EA 9394 should be cured for 3 to 5 days at 77° F (25° C)
to achieve full strength. An accelerated cure may be made by heating the leg in an oven at 150°
F (66° C) for one hour.
10. After cure, ream bore of bearing to diameter 0.7420/0.7412.
VERIFICATION METHOD:
Measure diameter of ream bore.
RELATED INFORMATION:
"Remove Nose Landing Gear Steering Bearing" on page 14-68
"Install New Nose Landing Gear Steering Bearing" on page 14-72
14.7.2.6.4 Install New Nose Landing Gear Steering Bearing
Use these instructions to install new nose landing gear steering bearing after removal, preparation, and
bonding.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Specific Tools Required
None
Parts Required
None
Aircraft System and Number
11—Landing Gear
Consumables
None
To Next Page
Loading...
