LANDING GEAR / NOSE LANDING GEAR 14-79
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
LSA-RM
Task Specific Training Required
No
Special Tools Required
ICA009750 (Wing Jack Point Adapter)
Rig Pin (Dia .1875 +.0100-.0000”)
Parts Required
None
Aircraft System and Number
11—Landing Gear
Consumables
None
1. Jack the aircraft up or weight the tail so that the nose gear is clear of the ground (use a safety
block under the forward hull if weighting the tail).
2. Connect actuator to Test box and set voltage to 13V. Actuate NLG Actuator to the full extend
position. The NLG Actuator will stop automatically when it reaches the full extend position.
NOTE: Allow gear to extend under its own weight (no additional weight
added).
3. Insert Rig Pin through the holes identified in the image.
To Next Page
Loading...
