ICON A5 - Page 708

16-84 PROPULSION / ENGINE
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 16
16.1.9.3 Inspection Instructions
16.1.9.3.1 Inspect Regulator Wires
Use the following procedure to inspect both Regulator A and B wires near the Regulator connectors.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
13—Propulsion
Consumables
None
TASK INSTRUCTIONS:
1. Remove the AFT bulkhead baggage panel. (See “Removal and Installation of Inspection Panels
and Fairings” on page 3-34.)
2. Locate the fuse box in front of the AFT bulkhead, LH as shown in Figure 16-49.