ICON A5 - Page 738

17-6 WING / TROUBLESHOOTING
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 17
None
TASK INSTRUCTIONS:
1. Ensure rigging is complete on flaps. (See “Inspect Flap Rigging” on page 9-65.)
2. Ensure rigging is complete on ailerons. (See “Inspect Roll Rigging” on page 9-17.)
3. Ensure all threaded fittings and attachments for flight controls have at least 3 full threads visible.
4. Verify all threaded fasteners for flight controls are secure.
5. Check flight control surfaces for axial and radial hinge play.
VERIFICATION METHOD:
Ensure each step above is completed to verify wing control surfaces.
RELATED INFORMATION:
"Inspect Roll Rigging" on page 9-17
"Inspect Flap Rigging" on page 9-65
17.2.4 Wing Bonded Joints, Cracks, or Delaminations
The following is to be used for inspecting the wing bonded joints, cracks, or delaminations.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
Borescope
Parts Required
None
Aircraft System and Number
14—Wing
Consumables
None