ICON A5 - Page 740

17-8 WING / WING GENERAL MAINTENANCE
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 17
17.3 Wing General Maintenance
17.3.1 General Wing Inspection
The following should be used to inspect the left and right wings of the A5.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
14—Wing
Consumables
None
TASK INSTRUCTIONS:
1. Inspect position light attached, lens condition and seal integrity.
2. Fold wings and verify the function of the wing fold sockets and release buttons.
3. Inspect fuel vent for obstruction and condition.
4. Visually inspect all metallic fittings in wing fold interface for corrosion and damage.
5. Visually inspect all metallic hinges for corrosion and damage.
6. Visually inspect placards for damage, peeling, fading and legibility.
7. Check bond integrity of vortex generators on wing skin. Ensure all 17 pair per wing are installed.
8. Count the wing vortex generators to confirm all are present. There should be 34 pair (17 pair per
side).