iPECS eMG80 - Page 160

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
147
the idle state.
6. The external caller may dial at any time during an Auto Attendant announcement and
must dial prior to the expiration of the CCR Analysis timer.
7. If the external caller dials an invalid selection or station, the system will play the “Invalid
Entry” prompt and allow re-entry. The DISA Retry Counter determines the number of
times the caller may retry entries.
8. If the external caller dials more than a single digit, the call is routed based on the
Station Numbering Plan.
9. Calls answered by an Auto Attendant (CCR) Announcement are interactive DISA calls
and are subject to conditions of a DISA call.
10. The “*” digit is reserved in the Audio/Text Tables to repeat the current or previous Auto
Attendant announcement.
11. The “#” digit is reserved for callers to access their Voice Mailbox remotely.
12. A CCR Announcement may be programmed to disconnect after playing.
13. The Auto Attendant Announcement feature is supported for DISA and DID calls as well
as Normal Ring assigned outside Lines.
14. With the optional second Voice Store Forward Gateway for eMG, System
announcement should be recorded in both the main and second gateway. Also, each
station and Line Voice Mailbox should be associated with one of the gateways.
15. When an iPECS UVM gateway is employed, each System announcement should be
recorded in both the built-in VSF gateway and the UVM gateway. In addition, each
Station and outside Line Mailbox should be associated with one of the gateways.
Programming
Keyset Admin.
STATION
VSF Access (PGM 113-Button 2)
CO/IP CO/IP Ring Assignment (PGM 144)
DID Service Attributes (PGM 145)
STATION GROUPS Station Groups (PGM 190)
Station Group Attributes (PGM 191)
SYSTEM DISA Retry Counter (PGM 160-Button 5)
DID/DISA Destination (PGM 167)
CCR Inter-digit Timer (PGM 180-Button 13)
VSF User Record Timer (PGM 181-Button 3)
VSF Valid User Message Timer (PGM 181-Button 4)
TABLES Customer Call Routing Tables (PGM 228)
Flexible DID Conversion Table (PGM 231)
STATION DATA
Web Admin.
VM Attributes

VSF Access
CO LINE DATA CO/IP Ring Assignment
DID Service Attributes
STATION GROUP
DATA
Station Group Assignment
Station Group Attributes