iPECS eMG80 - Page 278

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
265
activated, the receiving system is responsible for routing the call.
5. Incoming analog CO lines must provide Disconnect Supervision and the Open Loop
Detect timer must be set for proper operation.
6. Station calls may automatically forward using Preset Call Forward or may forward to
your integrated Voice Mailbox. If the Preset Call Forward timer is shorter than the Call
Forward No-Answer timer, calls will not forward over the network.
7. Network Call Forward ‘Follow-Me’ can only be deactivated at the original station.
8. Network Call Forward Follow-Me is only available when employing H.323/H.450
networking. When employing Qsig, Call Forward ‘Follow-me’ is not available over the
network.
9. For proper operation of Call Forward Follow-Me, all systems in the network must
employ the same type of Authorization codes.
10. Call Forward Follow-me is not available between networked systems.
Programming
Keyset Admin.
SYSTEM Networking Basic Attribute (PGM 320)
Networking CO Line Attribute (PGM 322)
Network Numbering Plan Table (PGM 324)
Network Feature Code Table (PGM 325)
NETWORKING DATA
Web Admin.
Net Basic Attributes
Net Supplementary Attributes
Net CO Line Attributes
Net Numbering Plan
Related Features
 Call Forward
 Authorization Codes (Password)
 DND (Do Not Disturb)
 DND - One Time DND
 Direct Inward System Access (DISA)
 Unsupervised Conference
 Dialing Restrictions
 Station Groups
 Station Speed Dial
 System Speed Dial
 Intercom Signaling Mode
 Call Forward, Preset
Hardware