iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
450
The available DECT handset, Base Station, WTIM is as below:
Note: Especially in Australia, NIOS of WTIM is at least 1.3Bd and only support GDC-600BE.
Operation & Programming
To set the multizone,
1. Set M/S (Master / Slave) Mode of WTIM before turning on the power.
2. After turning on all WTIMs, wait until all WTIMs connected with UCP.
3. Log in the system’s call server > DECT Data > DECT Multizone Support.
1) Fill in the sequence number of all WTIMs on Zone number field.
2) [Out range/Guard time/In range] parameters to be Set.
3) Click [Save and all WTIMs reset] button to apply.
To Next Page
Loading...
