iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
451
4. After all WTIMs work well, check Zone and Mode information about each WTIM in Device
IP plan (103).
Note)
DECT Handset registration: When DECT handset to be registered to system at first, UCP
system shares this information to all WTIMs of all zones (No need to register again in
each zone).
The following figure is the configuration for 3 zones: Zone 0 (3 WTIM), Zone1 (1 WTIM), and
Zone2 (1 WTIM).
1. To check the sequence number of WTIM in Device IP plan (PGM103).
To Next Page
Loading...
