iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
77
− Announcement number for the group (pre-recording the announcement is required)
− The Absent Supervisor timer
− The No answer timer
− The busy/no-answer Retry count
− The Interval time: Each member is called in turn at expiration of the interval timer
4. Set the Member Attributes by entering:
− Index number
− Type: Station, Individual CO, CO group, loop or Transit-out code (access loop for
networking call)
− The CO value: the supervisor can select a specific CO line or CO group for used to
call external members
− Dial number: The station or external party number
5. Press the Save button to store the Conference Group configuration.
1. Press [PGM] + “552”.
To activate conference group
2. Dial system conference group number.
3. Dial password of the system conference group.
1. Press [PGM] + “553”.
To deactivate conference group
2. Dial system conference group number.
3. Dial password of the system conference group.
1. Dial “Room Type Conf Group Join (“5*0”)” code.
To join system conference group
2. Dial system conference group number.
3. Dial password of the system conference group.
Operation
IPECS phone & LDP Phones
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “551” + [HOLD/SAVE]
To assign a {Conference Group Monitor} button
1. Lift the handset.
To initiate a Conference Group call
2. Dial “68”xxx, the Conference Group code and group number (xxx).
3. Enter the Conference group password, if assigned, members receive the Conference
Group call.
1. Answer the ringing call and receive recorded announcement, if assigned and recorded.
To enter a Conference Group call
2. Dial “1” to enter the conference or hang-up to reject the conference. For iPECS UCS clients,
To Next Page
Loading...
