Keba ServoOne User Manual

3Initialcommissioning
Chapter overview
Pictogram
Navigation ►Projecttree►Devicesetup►Initialcommissioning
Brief description l Theinitialcommissioningforthedrivecanbe
carriedoutwiththehelpofawizard.Thewizard
willtakeyouthroughtheprocessstep-by-step,
ensuringthattheavailableconfigurationoptions
arepresentedinaclearandmanageablemanner.
l Thischapterdescribeshowtheinitial
commissioningwizardworks.Thiswizardisused
tosetuptheinitialconfigurationfortheServoOne
andmakeitpossibletomovetheconnected
motor.
Contents
3.1 Initial Commissioning wizard 17
3.2 Automatic test 22
3.3 Motor 23
3.4 Encoder 24
3.5 Control 24
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
17
3 Initial commissioning
3.1InitialCommissioningwizard
The wizard guides you through the subject areas that are relevant for the initial
commissioning. Correct setting of the parameters permits controlled movement of
the drive via the manual mode window (for details see Section "Manual mode" on
page 467). Further settings must be made to exactly adapt the drive system to an
application.
3.1.1Hardwarerequirements
l Correctassemblyandinstallation,inlinewiththeintendeduse,asperthe
instructionsintheapplicableoperationmanual(seeSection"Applicable
documentation"onpage13).
l Voltagesupplies

o
24Vcontrolvoltage

o
Mainsvoltage
l Hardwareenable

o
SafeStandstill(ISDSH)

o
EnablePower(ENPO)
3.1.2PromptInitialcommissioning
If the KeStudioDriveManager5 is opened without an existing project, a prompt to
undertake initial commissioning appears automatically.

Keba ServoOne Specifications

General

Brand	Keba
Model	ServoOne
Category	Controller
Language	English