Keba ServoOne - Error 15: Parameter Error

11.6.16Error15:Parametererror
11.6.16.1Error15-1(emergencycode2350h)
Cause: Error while init current monitoring
Suggested steps:
Check the device setting! (If possible, try a different switching frequency.)
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
368
11 Alarms & warnings
11.6.16.2Error15-2(emergencycode2350h)
Cause: Error while init I2t monitoring
Suggested steps:
Please check the parameter of the motor protection
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.