Remote RMX-3200 Version 5.2x Configuration Guide
Configuring a Wireless Network with Remote RMX-3200: Configuring the Wireless Modem
11-7
4. Configure the following ppp encapsulation settings:
Remote method pap
Remote username isp@providerx.com and password PROVIDER1
A default route that uses the same subnet as the corresponding interface
Notes: Overrides the default route assigned to the Remote RMX-3200 via
command
config ip route default. PPP configured with the default
route option and command
config ip route default are mutually
exclusive. You should not have both configured.
PPP username and password may vary by wireless carrier. Consult your
network provider for the proper identification information.
Disabled LCP requests
config controller serial wan/1 encapsulation ppp
config controller serial wan/1 encapsulation ppp remote method pap
config controller serial wan/1 encapsulation ppp remote identity
isp@providerx.com PROVIDER1
config controller serial wan/1 encapsulation ppp defaultroute
config controller serial wan/1 encapsulation ppp lcp-requests
disable
5. (optional) Verify that the UMTS serial controller has been configured properly:
show controllers serial wan/1
The command response similar to the following displays:
6. Enable interface
serial wan/1:
config interface serial wan/1 enable
Note: The IP address of the serial wan/1 interface is assigned automatically by
PPP.
(Dub)>show controllers serial wan/1
serial wan/1 status=enabled link-state=up encapsulation=ppp
init-string=@gprsChat.txt
resource-state=assigned
signal-strength=fair (-82 dBm)
prl-version=51281 prl-size=5736
Next PRL update in: (unavailable)
description=UMTS wireless modem
ppp defaultroute=true
local-method=none local-identity=
remote-method=pap remote-identity=isp@providerx.com
mru=1520 mtu=1520
lcp-requests=disabled
(Dub)>
To Next Page
Loading...
