MEMory Subsystem 6
U8480 Series Programming Guide 165
Query
MEMory:TABLe:SGAMma?
The query returns a list of magnitude-phase pairs for the currently selected
Gamma table.
Query example
Error messages
– If a table has not been specified using the MEMory:TABLe:SELect command,
the data cannot be entered into the table and error –221, “Settings conflict”
occurs.
– If a magnitude or phase which is outside the allowed range is sent, error –222,
“Data out of range” occurs.
MEM:TABL:SGAM? Queries the magnitude-phase pairs for the
currently selected Gamma table.
To Next Page
Loading...