Keysight U8480 Series - Page 182

8 SENSe Subsystem
182 U8480 Series Programming Guide
Syntax
Example
Reset condition
On reset, automatic averaging is enabled.
NOTE
For most applications, automatic filter length selection
([SENSe[1]:]AVERage:COUNt:AUTO ON) is the best mode of operation. However,
manual filter length selection ([SENSe[1]:]AVERage:COUNt <numeric_value>)
is useful in applications requiring either high resolution or fast settling times,
where signal variations rather than measurement noise need filtering, or when
approximate results are needed quickly.
AVER:COUN:AUTO OFF This command disables automatic filter
length selection for the U8480 Series.
SENS
1
:COUN
AVER 0|OFF
1|ON
Space
?
:AUTO
:
ONCE