Keysight U8480 Series - Page 205

SENSe Subsystem 8
U8480 Series Programming Guide 205
Example
Reset condition
On preset (SYSTem:PRESet) and U8480 Series power-up,
[SENSe[1]:]CORRection:SGAMma:MAGNitude is set to 0.0.
Query
[SENSe[1]:]CORRection:SGAMma:MAGNitude?
The query returns the magnitude of the source reflection coefficient.
Query example
Error message
– If the input values are outside the acceptable range of values, error –222 “Data
out of range” occurs.
CORR:SGAM:MAGN 0.5 This command sets the magnitude of the source
reflection coefficient at 0.5.
CORR:SGAM:MAGN? Queries the current magnitude of the source reflection
coefficient.