Keysight U8480 Series - Page 207

SENSe Subsystem 8
U8480 Series Programming Guide 207
Example
Reset condition
On preset (SYSTem:PRESet) and U8480 Series power-up,
[SENSe[1]:]CORRection:SGAMma:PHASe is set to 0.0.
Query
[SENSe[1]:]CORRection:SGAMma:PHASe?
The query returns the phase of the source reflection coefficient.
Query example
Error message
– If the input values are outside the acceptable range of values, error –222 “Data
out of range” occurs.
CORR:SGAM:PHAS 45 This command sets the phase of the source
reflection coefficient at 45.
CORR:SGAM:PHAS? Queries the current phase of the source reflection
coefficient.