SENSe Subsystem 8
U8480 Series Programming Guide 209
Query example
Error message
– If you set this command to ON and [SENSe[1]:]CORRection:CSET3:STATe
is currently ON, it will set [SENSe[1]:]CORRection:CSET3:STATe to OFF
and error –221, “Settings conflict; Table based gamma is being switched off”
will occur. This behaviour indicates that both
[SENSe[1]:]CORRection:SGAMma:STATe and
[SENSe[1]:]CORRection:CSET3:STATe are mutually exclusive.
CORR:SGAM:STAT? Queries the current state of the Single Point Gamma
correction.
To Next Page
Loading...