Keysight U8480 Series - Page 326

12 TRIGger Subsystem
326 U8480 Series Programming Guide
Example
Reset condition
On reset, the trigger source is set to IMMediate.
Query
TRIGger:SEQuence[1]:SOURce?
The query returns the current trigger source.
Query example
NOTE
The trigger source is set to IMMediate on U8480 Series power-up.
The MEASure and CONFigure commands automatically set the trigger source to
IMMediate.
The READ? query or MEASure command should not be used if the trigger source is
set to HOLD.
TRIG:SOUR IMM This command configures the U8480 Series
for immediate triggering.
TRIG:SOUR? Queries the current trigger source for the
U8480 Series.