2 MEASurement Commands
90 U8480 Series Programming Guide
Example
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command subsystems. The parameters must
be entered in the specified order. If parameters are omitted, they default from the right. The parameter DEFault is used as a placeholder.
Specifying DEF leaves the parameter value unchanged.
[b] When the measurement result is linear, this parameter represents the number of significant digits. When the measurement result is
logarithmic, 1 to 4 represents 1, 0.1, 0.01, and 0.001 respectively.
MEAS? -10DBM,1,(@1) Queries the measurement using an expected
power level of –10 dBm and a resolution
setting of 1.
To Next Page
Loading...