MD-11 Flight Crew Operations Manual
k
Engines -
Controls and Displays
Eng.30.8
4. EGT
Columns are white but turn amber if EGT exceeds the amber line or red if
EGT exceeds redline limit. During starting there is an additional red line limit
for start. A cyan lightning symbol appears (overwrites digits) when ignition
for that engine is on. Maximum redline exceedance, if any, is shown in amber
at the top. This exceedance can be reset with the ENG MAX POINTER
RESET button on the forward overhead panel.
5. N1
Throttle position is a white T riding on the side of each column. Computed
N1 is a magenta V on the side of each column. When the throttle is set to a
computed thrust, the T will fit in the V. The thrust reverser display is on top
(overwrites digits). It is blank for reverser stowed, amber U/L for in transit,
and green REV for reverser fully deployed. Maximum redline exceedance, if
any, is shown in amber at the top. This exceedance can be reset with the ENG
MAX POINTER RESET button on the forward overhead panel.
NOTE: If one of the two ECU channels is inoperative, N1 will not be
displayed until the FUEL switch is moved to on.
October 02, 2006
To Next Page
Loading...