MD-11 Flight Crew Operations Manual
k
FMS -
Controls and Displays
FMS.30.119
Confirmed EO PERF Page
Confirming the EO condition results in the MCDU display shown above. CRZ FL
ABOVE MAX FL in the SP shows that the three engine CRZ FL was FL 330.
After confirming the EO condition, the PERF page displays the MAX ENG OUT
altitude. Maximum altitude is that altitude maintained with two engines operating
at MCT with a 100 fpm climb available. Pilot confirmed EO request results in
selecting the MCT limit for the remaining two engines as shown on next page. The
selection is thrust limit and not EO required thrust.
NOTES: For all 2 engine accelerations, climbs, and driftdowns above
the 2 eng max altitude (except max descent), operation is at MCT
and 2 engine speeds selected from 2 engine flight test data.
The select AUTO prompt will not be available on the THRUST
LIMITS page until the EO has been cleared. The thrust limits will
remain in MCT until AUTO is selected on the THRUST LIMITS
page.
The EO mode cancels time constraints and the DECEL mode.
To reselect a 3 engine state, the pilot must again push the ENG OUT
key to display the CONFIRM ENG OUT CLEAR prompts. Selecting
CLEAR will cause the ENG OUT function to deactivate
(performance predictions revert to 3 engine).
LB1-3-0134
1L
2L
3L
4L
5L
6L
1R
2R
3R
4R
5R
6R
October 02, 2006
To Next Page
Loading...