EasyManua.ls Logo

KLM MD-11 - FMS Interfaces

KLM MD-11
888 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MD-11 Flight Crew Operations Manual
k
FMS -
Components
FMS.20.2
FMS Interfaces
LB1-3-0052
FCC (2) receive:
Components Receiving Data from the FMS
Horizontal command.
Roll limits.
Gross weight.
Airspeed target.
Altitude target.
Vmax and Vmin.
Flap and slat retract speeds.
EPR or N1.
BTM/TPI receives:
FSC and FQDCU receive:
Zero fuel weight.
Zero fuel weight CG.
Dump to gross weight.
Total refuel quantity.
Ballast fuel quantity.
Fuel freeze point.
Ballast cancel.
ACARS (if activated) receives:
Downlink data and/or,
ETA.
Date.
Flight number.
Flight phase.
Origin airport.
Destination airport.
Ground speed.
Flight number.
Date.
Time.
CPCS receives:
Destination altitude.
Time at top-of-descent.
ETA.
DFDAU receives:
CFDS receives:
EIS receives:
MCDUs receive:
Display data.
Present position.
Components Sending Data from the FMS
Flight recorder parameters.
Flight number.
Date.
Time.
Baro corrected altitude.
CAS.
Maintenance data.
Initial latitude.
Initial longitude.
ND data.
Deviations.
ADL (if installed) receives:
DLDR data.
GPWS (if connected) receives:
ADAS (if connected) receives:
Flight recorder data.
GNS (2) (if activated):
True airspeed.
Pressure altitude.
Gross weight.
CG.
ZFWCG.
ACARS (if connected) send:
Uplink data.
CHRONO sends:
IRU (3) send:
EIS send:
WBS (2) (if installed) send:
Throttle resolver angle.
Fuel flow.
FCC (2) send:
Average flap position.
Edit CAS and Mach.
Selected airspeed and Mach.
Selected altitude.
Selected vertical speed.
Actual N1 or EPR.
Operating mode signals.
GMT and date.
Engine bleed data.
ESC sends:
ADL sends:
Nav data base.
MCDU sends:
Button push data.
CFDC sends:
Commands.
VOR and DME (2) send:
Frequencies.
Bearings.
DME distance.
CADC (2) send:
Altitude.
Mach and Airspeed.
Ram airspeed.
Temperature.
FQDCU sends:
Fuel quantity.
Center of gravity.
ILS (2) send:
IRU (3) receive:
Frequencies.
Loc deviations.
FCP sends:
Preselected altitude.
Mode request.
GNS (2) (if installed) send:
PPOS latitude and
longitude.
Ground speed.
Time, date.
Sensor status.
Inertial altitude.
Position.
Mag and true heading.
North/South & East/West veloc.
Flight path angle and accel.
Roll and pitch angle.
Yaw rate.
Ground speed.
Inertial vertical speed and accel.
October 02, 2006

Table of Contents