MD-11 Flight Crew Operations Manual
k
Flight Controls -
Controls and Displays
Flt.30.15
3. Stabilizer Position - green, amber
Stabilizer position is depicted inside the schematic fuselage.
On the ground, stabilizer position is green when within the computed takeoff
band.
If stabilizer trim is more than 2 units different than computed trim setting on
the T/O page, the takeoff warning sounds when takeoff power is applied.
Trim limits are shown when the stabilizer has reached maximum travel. The
upper limit is depicted above the stabilizer position by a downward pointing
amber triangle. The lower limit is depicted by an upward pointing amber
triangle.
4. Flap Position - grey with white or amber
Flaps are shown under the wing as a fixed-size grey box with white digital
readout of the flap position.
Retracted - Boxes are removed.
Position Not Available - An amber "X" appears in the respective left or right
(inboard and outboard) flap position box.
5. Slat Position - white, amber
Slat position is displayed below the schematic fuselage. There is no
annunciation when the slats are retracted.
SLAT EXT - The slat position annunciation appears in white.
SLAT DISAG - The slat position annunciation appears in amber.
October 02, 2006
To Next Page
Loading...