Korg Oasys - Rppr Playback

Creating songs (Sequencer mode)
118
2. SelecttheRPPRSetuptaboftheP5:Pattern/RPPR
page.Inthispage,theRPPRfunctionis
automaticallyturnedon.
3. Selectthekeytowhichthepatternwillbe
assigned.
SelectC#2.HolddowntheENTERswitchandplay
akey,orusethescrollbarlocatedattherighttofind

thekey.
Note:C2andlowerkeysareusedtostopplayback,
andcannotbeassigned.
4. Check“Assign”forC#2.
5. Set“Bank”toPreset,andset“PatternName”to
P00.
6. Set“TrackName”toT01.
Theselectedpatternwillbeplayedaccordingtothe
settings(program,etc.)ofthetrackyouselecthere.
7. WiththeC#2parameterselected,presstheCopy
button.
8. Assignpatternstootherkeys.
SelecttheD2parameter,andpressthePastebutton.
The“A s s i g n , ” “Bank,”“PatternName,”“Track
Name,”“Mode,”“Shift,”and“Sync”settingsyou
madeinsteps5and6willbecopiedautomatically.
9. Modifyonlythe“PatternName.”Select“Pattern

Name,”andpresstheswitchtoselectP01.
10.SelecttheD#2parameter,andpressthePaste
button.
The“A s s i g n , ” “Bank,”“PatternName,”“Track
Name,”“Mode,”“Shift,”and“Sync”settingsyou
madeinsteps5and6willbecopiedautomatically.
Asyoudidinstep9,set“Pattern”toP02.
Note:When
makingRPPRsettings,youcanusethe
CopybuttonandPastebuttoninthiswayto
efficientlyassignthe“Bank,”“PatternName,”and
“TrackName”etc.toeachkey.
11.Asdescribedabove,assignseveralotherpatterns
suchasP03andhigher.
12.PresstheC#2key.Theassignedpatternwillplay.
Takeyour
fingerofftheC#2key,andpresstheD2
key.Thepatternwillchange,andplaybackwill
begin.Atthistime,thepatternoperationwill
dependonthe“Sync”and“Mode”setting.
Set“KEY”toC#2,andset“Sync”toMeasure.Make
thesamesettingforD2(Seethediagramabove).
Nowpressthenotesconsecutively.Noticethatthe
patternsoperateinadifferentway.
Withthe“Measure”setting,patternswillbe
handledinone‐measureunits.Thesecondand
subsequentpatternswillstartinsyncwiththeend
ofpreviouslyplayedpattern.
Ifyouchangethe“Mode”settingtoOnce,theentire
patternwillplaybacktotheendevenifyourelease
yourfingerfromthekeyboardimmediately.
13.Tostopplayback,eitherpressthesamekeyonce
again,orpresstheC2orlowerkey.
RPPR playback
Let’susetheRPPRyoucreatedtoperformintheP0:
Play/REC–MIDITrackProgSelect/Mixerpage.