Korg Oasys - Global Audio Settings; MIDI-Related Settings P1: MIDI; Pedal and Other Controller Settings

Global audio settings
153
Global audio settings
Making audio input settings for all modes,
except Sampling mode
ThesettingsontheAudiotabselecttheinputsource
fortheanalog/digitalaudiosignal,theinputlevel,bus,
andmastereffectsendsforuseinallofthemodes
(Program,Combi,etc.)exceptforSamplingmode.If
youwanttousethesesettings,checktheUseGlobal
Settingoptionin
thedesiredProgram,Combi,orSong.
MIDI-related settings P1: MIDI
MIDI Setup, MIDI Filter, External
HereyoucanmakeMIDIsettingsfortheentire
OASYS.Youcanalsousethemenucommandsofthis
pagetotransmitMIDISystemExclusivedatadumps.
Hereyoucanalsoassignthefunctionsthatthefaders,
knobs,andswitcheswillhavewhenthecontrolsurface
CONTROLASSIGNEXTERNALison.
Pedal and other controller settings
TheControllertaboftheController/Scalepageletsyou
controlhowthefootswitchesandfootpedalwillwork,
aswellassettingupcontrollermappingsforthe
KARMAcontrolsandthedrum/chordpads.
Specifying the function of the
ASSIGNABLE Switch and ASSIGNABLE
Pedal
Assignable Switch
FootSwitchAssignletsyouassignafunctiontoa
footswitch,suchastheoptionalKorgPS‐1,connected
totherear‐panelASSIGNABLESWITCHjack.
Youcanchoosefromthefollowingfunctions:
•Alternatemodulationsource
• Effectdynamicmodulationsource
•Switchportamentoon/off
• Controlthesostenutoeffect
•Turnthesoftpedaleffecton/off
•Select
programsorcombinations(up/down)
•Start/stopthesequencer
•Punch‐in/outonthesequencer
•Taptempo
•KARMAon/off
•Thefunctionsofcontrollerssuchasthejoystickor
ribboncontroller
Assignable Pedal
Youcanspecifythefunctionthatwillbeperformedby
anassignablepedal(theoptionalXVP‐10EXP/VEL
pedalorEXP‐2footcontroller)connectedtothe
ASSIGNABLEPEDALjack.
•Thisissetby“FootPedalAssign.”
Youcanchoosefromthefollowingfunctions.
• Mastervolume
•Alternatemodulationsource
•Effectdynamicmodulationsource
•Portamento
pitchchangespeed
•Volume
•Thepanfollowinganinserteffect
•Pan
•Volume
•Sendlevelstothemastereffects
• Duplicatethefunctionofanothercontroller,suchas
thejoystickorribbon
Note:Youcanusethisasasourceforalternate
modulationoreffectdynamicmodulation,anduseit
tocontrolprogramparametersoreffectparameters.
In
thiscase,set“FootSwitchAssign”toFootSW(CC#82),
and“FootPedalAssign”toFootPedal(CC#04).
Changing Programs and Combinations with the
the foot switch
1. Pressthe“FootSwitchAssign”popupbutton,and
selecteitherProgramUporProgramDown.
ProgramUpwillcausethenexthigherprogram
numbertobeselectedeachtimeyoupressthefoot
switch.