Korg Oasys - Page 160

Settings for the entire OASYS (Global mode)
152
Linking KARMA to programs and
combinations
YoucanspecifywhethertheKARMAsettingswritten
toaprogramorcombinationwillalsobeselectedwhen
youselectthatprogramorcombination,orwhetherthe
KARMAsettingswillnotchangewhenyouswitchthe
programorcombination.
WhentheOASYSisshippedfromthefactory,the
formersettingis
selected.Youcanusethelattersetting
ifyouwanttousethesameKARMAsettingsto
generatephrasesandpatternswhileyouselectandtry
outdifferentprogramsandcombinations.
IftheLoadKARMASettingsWhenChanging
ProgramorCombinationboxesareselected,selecting
aprogramorcombinationrespectivelywill
alsoselect
theKARMAsettingsthatarewritteninthatprogram
orcombination.
Globally disabling KARMA
IfAllKARMAOffisenabled,allKARMA
functionalitywillbeturnedoff.KARMAwillnot
operateeveniftheKARMAON/OFFswitchison.
Recalling the last-selected mode and page
at power-on
ThestateofOASYSwhenthepoweristurnedonwill
dependonthesettingof“PowerOnMode”.
IfPowerOnModeissettoReset(factorysetting),
OASYSwillautomaticallyselecttheCombination
modeP0:Play.
IfPowerOnModeissettoMemorize,OASYSwill
poweronusingthe
samemodeandpagethatwere
selectedwhenthepow erwasturnedoff.
Sounding a beep when you press the LCD
screen
IfBeepEnableisselected,abeepwillsoundwhenyou
pressanobjectintheLCDscreen.Uncheckthisitemif
youdon’twantabeeptosound.
Protecting the memory
IfoneormoreoftheMemoryProtectcheckboxesare
checked,operationssuchaswriting,loading,orsong
recordingwillbeprohibitedforthecorresponding
typeofmemory.
Adjusting the brightness, contrast,
and color of the LCD
YoucanadjusttheappearanceoftheLCDdisplayby
usingtheLCDSetupmenucommand,ontheGlobal
BasicSetuppage.Todoso:
1. PresstheGLOBALswitchtoenterGlobalmode.
2. PresstheBasictabinthelowerline,andthenthe
Basictablocatedaboveit.
TheGlobalBasic
Setuppagewillappear.
3. Fromthepagemenulocatedintheupperrightof
theLCD,chooseLCDSetup.
TheLCDSetupdialogwillappear.
4. Settheparametersasdesired.PressingtheRESET
buttonwillresettheparameterstotheirdefault
values.
5. PresstheOKbuttontoconfirmthechanges,or
press
theCancelbuttontoreverttotheprevious
settings.
Tuning and transpose
settings
V
elocity/aftertouch curve
settings
Effect bypass settings
KARMA setting
s
Memory prote
ct
settings
Select the mode that is
selected at power-on
Beep setting