Korg Oasys - Dynamic Modulation, MIDI;Tempo Sync; And Common FX LFO

Dynamic modulation, MIDI/Tempo Sync, and Common FX LFO
195
Dynamic modulation, MIDI/Tempo Sync, and Common FX LFO
Dynamic modulation (Dmod)
Dynamicmodulation(Dmod)letsyouuseMIDI
messagesortheOASYS’scontrollerstomodulate
specificeffectparametersinreal‐time.
Formoreinformation,see“DynamicModulation
Sources(Dmod)”onpage 1030oftheParameterGuide.
Dmod Example
Asanexample,let’ssetupdynamicmodulationto
controlaneffectparameterinrealtime.
1. Asdescribedintheprocedurefor“Program
Effectssettings”onpage 189,setIFX1to091:L/C/R
BPMDelay.Verifythatyou’rehearingadelay
effect.
2. GototheProgramP8:InsertEffect–IFX1page.
Using Dmod to change the delay level via the
Joystick
3. SetInputLevelDmodto+100.
4. SetSourcetoJS+Y:CC#01.
Thedelaysoundwilldisappear.
Theinputleveltotheeffectcanbecontrolledbythe
joystick.Asyoumovethejoystickawayfromyourself,
thedelaysoundwillgraduallyincrease.
Using Dmod to change the feedback level via SW1
5. IntheP1:Basic/Vector–SetUpControllerspage,
settheSW1functiontoSW1Mod.CC#80,andthe
ModetoToggle.
6. ChooseP8.SettheFeedbackSourcetoSW1Mod.
(CC#80),andsetAmountto+30.
Whenyoumovethejoystickawayfromyourselfand
presstheSW1switch,thefeedbacklevelwill
increase,
andthedelaysoundwillcontinueforalongertime.
TheAmountsettingspecifiesthefeedbacklevelthat
willbeineffectwhentheSW1switchispressed.If
Amountissetto–10,pressingtheSW1switchwill
reducethefeedbacklevelto0.
MIDI/Tempo Sync
MIDI/TempoSyncletsyousynchronizeeffectsLFOs
anddelaytimestothesystemtempo.Formore
information,see“TempoSynchronization”on
page 789oftheParameterGuide.
Using the MIDI/Tempo Sync function to
synchronize the delay time to KARMA tempo
changes.
1. Setuptheeffectsasdescribedunder“Dmod
Example”onpage 195.
2. SetBPMtoMIDI.