Korg Oasys - Sampling and Editing in Sampling Mode

Sampling (Open Sampling System)
130
Using the metronome
Itisconvenienttousethemetronomewhenyouwant
toplayaprogramorcombinationataspecifictempo
andsampleyourperformance.
YoucanmakemetronomesettingsinMetronome
Setup,inProgramorCombinationP0:Play–Audio
Input/Sampling.Youmightfinditconvenienttoset
“Bus(OUTPUT)Select”to
oneoftheIndiv.1–8
outputs,connectthe(INDIVIDUAL)1–8jackstoa
mixer,andmonitorthemetronomeviayourmixer.
Automatically setting-up for the desired
sampling method (Auto Sampling Setup)
Ineachmode,AutoSamplingSetupautomatically
makestheappropriatesettingsforthesampling‐
relatedparameters.ForexampleinProgrammodeyou
canusethistomakethenecessarysettingsfor
resamplingyourplayingonaprogram,ortomake
settingsforsamplingonlyanexternalaudiosource
whileyoumonitor
yourplayingonaprogram.
However,theseautomaticsettingsassumetypical
situations,soyou’llneedtoadjusttheparametersto
meetyoursituation.
Thisfunctionisavailableinthefollowingpages:
Sampling and editing in Sampling mode
InSamplingmode,youcanrecordsamples,andedit
sampledatathatyousampledorloadedfrommedia
(includingWAVEandAIFFformats).Youcanalso
assigntheeditedsamplestoindexes(zones)tocreatea
multisample.
Samplingmodepagestructure
Fordetailsonhowtoaccesseachmodeandpage,refer

to“Basicoperations”onpage 38.
SamplingcanbeperformedinanypageP0–P9of
SamplingmodebyusingtheREC/WRITEswitchand
theSTART/STOPswitch.Recording‐relatedsettings
suchasinputlevelaremadebytheparametersofP0:
Recording,andthesesettingsarevalidfortheother
pagesaswell.
Theselectedmultisampleorsamplecanbeplayed
fromthekeyboardinanypage,allowingyoutohear
theresultsofyoureditingineachpage.
Mode Page
Sampling Sampling P0: Recording
Combination Combination P0: Play– Audio Input/Sampling
Program Program P0: Play– Audio Input/Sampling
Sequencer
Sequencer P0: Play/REC– Preference, Audio
Input/Sampling
Page Explanation
P0: Recording
•Sampling and resampling
•Various settings for sampling
•Audio input settings
•Edit using the control surface
P1: Sample Edit • Sample waveform editing
P2: Loop Edit
•Sample playback parameter settings
•Start, loop start, and end address settings
•Loop and reverse playback on/off
•Editing operations such as Time Slice and
Time Stretch
P3: Multisample
Edit
•Assign samples to multisamples, and
specify the zone and original key
P4: EQ/Controll
er
•EQ adjustments for multisample playback
•Assign functions to controllers
P5: Audio CD
•Play back audio CDs
•Rip audio CDs
P6: ---
P7: ---
P8: Insert Effect
•Select and edit insert effects, adjust send
levels to the master effects, and specify the
routing to the outputs
P9: Master,
Total Effects
•Select and edit master send effects and
total effects