Korg Oasys - Page 193

Other disk operations Restoring the factory settings
185
• WaveSequences:150WaveSequencesloadedinto
BankINT
9. PresstheOKbuttontoloadthedata.
Loading from the Restore CD
Ifthesoundshavesomehowbeenerasedfromthe
internaldrive,youcanalsoloadthemfromCD:
1. InserttheincludedCD“Restore1/4”intothe
OASYS’sCD‐R/RWdrive.
2. PresstheDISKbuttontoenterDiskmode.
3. PresstheLCDscreentomaketheOASYS
recognizethedisc.
4. GototheLoad
taboftheFilepage.
5. UseDriveSelecttoselectCDD.
TheLCDscreenwillshowthefilesandfoldersonthe
disk.
6. SelectthePRELOAD.PCGfile.
Theselectedfilewillbehighlighted.
7. ChoosetheLoadselectedcommandfromthepage
menu.
8. Use“.PCGContents”toselectthedatayouwantto
load.
Tocompletelyrestorethefactorysounds,
selectAll.
9. PresstheOKbuttontoloadthedata.
Neverattempttoremovemediawhiledataisbeing
loaded.
Restoring EXs samples to the factory
defaults
WhentheOASYSisshippedfromthefactory,thePCM
memorybankissettoloadtheEXs1ROMExpansion
samplelibraryatstart‐up.Formoreinformation,see
“A b o u t theOASYS’PCMmemory”onpage 35.To
restoretheOASYStothissetting:
1. Pressthefront‐panelGLOBALbuttontoenter
Globalmode.
2. PresstheEXITswitchtoaccesstheP0:BasicSetup
page.
3. Pressthepagemenubutton(locatedintheupper
rightoftheLCD),andselect“ExpansionSample
Setup.”
Adialogboxwillappear.
4. SelectthedesiredEXsPCMbank.
Check“EXs1ROMExpansion284MB,”toloadthe
multisamplesand
samplesforEXs1.
5. PresstheOKbutton.
AfterpressingOK,theEXsconfigurationwillbe
adjustedimmediately,andsampleswillbeloadedor
un‐loadedasnecessary.Loadingsamplesmaytake
sometime.
TheselectedEXswillalsobeloadedautomaticallyat
power‐on.