2NJ/2RK
2-67
Note in the installation
When the outline of IC card reader is smaller than the holder, the receiving parts are positioned in a sheet marking
position.
(When it needs to fix, fix with the dual tape etc.)
When the thickness of IC card reader is thin and there is far from the table glass, insert the spacer between the
holder and then adjust the height (The space is to 5mm extent.)
13. Connect the USB connector (a) to the USB interface slot (b).
14. Insert the USB cable(c) into the wire guide(d).
Figure 2-127
15. Bundle the surplus length of the cable (a) and hook it on the hook (b) of the main unit.
Figure 2-128
c
a
b
d
To Next Page
Loading...
