2WA/2NJ/2RK
4-217
(10-6) Adjusting the angle of trailing edge
Perform the following adjustment if the trailing edge of the copy image is laterally skewed.
Procedures
1. Place an original on the DP and press-
the [start] key to make a test copy.
2. If the gap of trailing edge exceeds
theRefer ence value, perform the fol-
lowingadjustment.
Refer ence value
For simplex copying: Within ±3.0 mm
For duplex copying: Within ±4.0 mm
Figure 4-329
3. Open the DP upper cover (a).
4. Remove the right hinge cover (b).
5. Remove the screw (c) and then remove
theleft hinge cover (d).
Figure 4-330
Original
Copy Sample1 Copy Sample2
3mm/4mm
3mm/4mm
14j0515
b
a
d
c
14j0516
To Next Page
Loading...
