Kyocera TASKalfa 8002i

2WA/2NJ/2RK
7-55
(4-10) The irregular misalignment occurs between the leading edges of the original
and copy image (Variation of paper leading edge timing)
(4-11) Blurred characters
Step Check description Assumed cause Measures Reference
1 Executing U034 The leading edge timing is
not properly adjusted.
Adjust the leading edge tim-
ing at U034 [LSU Out Top].
Executing
U034
2 Executing U051 The paper loop amount
before registration is
improper.
Execute U051 to adjust the
paper loop amount before
registration.
Executing
U051
3 Checking the wire The paper conveying
clutches and the motors
cannot operate smoothly
since their connectors are
not properly connected.
Reconnect the connectors of
the paper conveying clutches
and the motors.
4 Checking the clutches and
motors
The paper conveying
clutches and the motors
cannot operate smoothly
since they are not properly
attached.
Reattach the paper convey-
ing clutches and the motors.
5 Detaching and Reattach-
ing the feed drive unit
The paper conveying drive
is faulty and it cannot oper-
ate smoothly.
Replace the feed drive unit. Detaching
and Reat-
taching the
feed drive
unit
Step Check description Assumed cause Measures Reference
1 Checking the paper Unspecified papers are
used.
Replace with the paper within
the specification.
2 Checking the settings The media type is not
properly set.
Set the proper media type via
the System Menu.
3 Applying the grease The drives from the con-
veying motors are not
smoothly transmitted.
Apply the grease to the gear.
4 Checking the conveying
guide
The conveying guide is
deformed.
Replace the conveying guide.
5 Checking the fuser unit The fuser front guide is
deformed or the fuser
pressure is uneven.
Replace the fuser unit. Detaching
and Reat-
taching the
fuser unit