2WA/2NJ/2RK
3-65
(9) Fuser section
The paper from the transfer and separation section is pinched between the heat roller and the press roller.
The fuser roller is heated by the IH, and the paper is pressed by the press roller with the pressure added by
the pressure spring toward the fuser roller, so toner is fused on the paper by that heat and pressure.
The surface temperature of the fuser roller and the press roller is detected by the fuser thermistor and con-
trolled by the Engine PWB.
Figure 3-49
8
4
5
11
9
7
2
3
10
1
12
6
1. Fuser belt
2. IH core
3. Fuser thermistor
4. Separator
5. Press roller
6. Press roller separation claw
7. Actuator
(Eject sensor)
8. Fuser eject roller
9. Left fuser eject roller
10. Pressure switching cam
11. Fuser frame
12. Front fuser guide
13. Fuser charger needle
To Next Page
Loading...
