Kyocera TASKalfa 8002i - (4-12) Offset

2WA/2NJ/2RK
7-56
(4-12) Offset
Step Check description Assumed cause Measures Reference
1 Checking the paper Unspecified papers are
used.
Replace with the paper within
the specification, or change
to the media type setting
closest to the specified paper.
2 Checking the settings The media type is not
properly set.
Change the settings accord-
ing to the media type (paper
weight).
3 Executing U106 The transfer voltage is not
properly set.
Reset the transfer bias to the
default value at U106.
Executing
U106
4 Checking the transfer belt
unit
The transfer belt is dirty. When the image failure
appears in the transfer belt
circumference interval, clean
the transfer belt.
5 Executing U161 The higher fuser tempera-
ture is set.
Execute U161 [Print] and
reset the fuser temperature to
the default value.
Executing
U061
6 Checking the fuser unit The fuser belt is dirty. When the image failure
appears in the fuser belt cir-
cumference interval, clean
the fuser belt.
Detaching
and Reat-
taching the
fuser unit
7 Checking the fuser high-
voltage PWB
The bias from the fuser
high-voltage PWB cannot
be applied to the fuser dis-
charging needles in the
fuser unit.
Check if the bias contact con-
tacts the fuser unit or the con-
nectors on the fuser high-
voltage PWB are properly
connected. If the bias is not
output from the fuser high-
voltage PWB, replace the
fuser high-voltage PWB.
8 Detaching and Reattach-
ing the high-voltage PWB
The high-voltage PWB is
faulty.
Replace the high-voltage
PWB.
Detaching
and Reat-
taching the
high-volt-
age PWB
9 Checking the fuser unit The fuser belt surface has
some scratches.
Replace the fuser unit. Detaching
and Reat-
taching the
fuser unit